We start by pumping out any standing water, then move straight into liner installation and humidity control.
A rushed encapsulation job with unsealed seams or unwrapped piers looks fine on day one and fails within a season. We treat seam sealing and pier wrapping as core parts of the install, not optional add-ons that get skipped to save time.
Every crew member is trained specifically on liner installation, seam sealing, and vent encapsulation, not general basement work.
Our technicians carry encapsulation materials on the truck for most standard-size crawl spaces, cutting down on return visits.
Pricing is based on your crawl space's actual square footage and condition, quoted in writing before liner installation begins.
A dedicated crawl space dehumidifier is sized to your square footage, not a one-size-fits-all unit.
Every Pullman, WA Crawl Space Encapsulation job starts with an inspection, not a generic package — here's what that typically includes.
Extraction equipment includes submersible pumps sized for tight crawl space access points.
Liner thickness is selected based on foot traffic and how the space will be used going forward, not a flat default.
Open foundation vents pull in humid outside air, which is often the real driver of Pullman, WA crawl space condensation — we seal them as part of encapsulation.
A crawl space needs its own sump basin and discharge line separate from any basement system, since the two spaces drain differently.
We also check subfloor insulation for water damage and replace anything compromised before closing the liner.
We ask about standing water, musty odor, and vent condition to gauge scope before scheduling the inspection.
We take humidity and moisture readings to establish a baseline before recommending a system.
You'll see square footage, liner grade, vent sealing, and dehumidifier specs broken out in the written estimate.
Most residential encapsulations finish in one to two days depending on square footage and access.
"Found out our old vapor barrier had huge gaps at every seam. They redid it properly and sealed the vents too."
— Pullman Homeowner
"Sump discharge from the old system was dumping water right back next to the foundation. They rerouted it and the crawl space finally dried out."
— Pullman Customer
"They caught duct condensation we didn't even know was happening down there. Sealed everything up during the same visit."
— Pullman Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Pullman Customer
A vapor barrier is just the liner on the ground; full encapsulation seals vents, walls, and often adds a dehumidifier for complete moisture control.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
In most Pullman, WA climates, yes — open vents pull in humid air that undoes a lot of the benefit of the liner alone.
Often yes, if the crawl space is the source — sealing and dehumidifying typically resolves musty odors within a few days of installation.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Most residential jobs finish in one to two days depending on square footage and how much prep work is needed.
We encapsulate crawl spaces throughout Pullman and the surrounding Pullman, WA service area, including the zip codes listed below.
Zip codes we serve in Pullman, WA: 99163 99164
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
